After restarting KStars, I can't get any optical trains to appear in any dropdowns. Only if I go into the optical trains editor, change something, only then do the dropdowns populate. But if I exit KStars and restart it, the dropdowns are empty again.
An expanded view of the optical trains. Ignore the "New Train", it was added by mistake and I can't get rid of it.
I've seen this behavior. Let me try to reproduce it so I can track down what's going on. Most likely is that database profile information was not saved properly.
Please have the system remember autofocus focus settings with each train, for those with two or more motorized focusers that require totally different settings,
"Please have the system remember autofocus focus settings with each train, for those with two or more motorized focusers that require totally different settings"
I second this. I have two telescopes, an 80mm refractor, and an 8" Newtonian, each with an autofocuser, and they each require different autofocus parameters to get good results.
Same here, I have 4 setups (never too much ), 3 refractors and one reflector. It would be great to keep per setup settings.
And I also have the same problem with the delete button, can't delete the incorrect optical trains inserted, the button is not available , it's not even clickable as described.
We'll move the settings to the trains, but there is a lot of work to do. Also, now most of the settings are global so there are retained regardless of train or even profile.
Which focus setting should be saved for each train? Let's start with a small important set of settings then we can extend this later.