Hello, I would like to drive my arduino nano which controls a servo to remove my cover with Kstars Ekos. How do I proceed?
Read More...
Hi all,
the QHY183C is now detected, but when i take a picture it can stop downloading the picture . I was working fine for a week , now it doesn't ???? why ???
thanks for your support .
Richard
Read More...
Hi all,
Now it' works with Aurneth advices " download the QHYCCD SDK, extract the archive and copy across their fxload to replace the Ubuntu fxload"
best regards, thanks to all for your support
Richard
Read More...
hi Aurneth,
thank you for your support . i try many times to find QHYCCD USB3 on the ekors menu . As i am a newbie on linux , i use ubuntu mate V20 but the Linux commands do not work .
thanks for your help Richard
Read More...
Hi ,
i'm using Kstars with ekos under UBUNTU MATE 20.04 my QHY183C is not detected. i used it n RPI4 it works well ? any idea , thank you for your help Richard
Read More...
Good morning,
just to know if and where i can download INDI WEB MANAGER for win10 .
thanks a lot
Richard
Read More...
i have un install an re install Kstars , still same issue with the DSLR only in remote mode , it works in local mode with VNC (for me)
Read More...
Hi all,
it works in local when i launch ekos kstar from my RPI.
But it doesn't work in remote mode from my win10 PC at home ?
i will try to reinstall win10 Kstars suite i think that it' s coming from the installation . keep you in the loop .
Richard
Read More...
Donwload torrent with Wuze unzip the image it works thanks
ubuntu-mate.community/t/ubuntu-on-raspberry-pi-3b/16309/2
Read More...
Hi all ,
I just by another RPI3+ in order to install another stellarmate on the PI . but i can't boot with ubuntu mate 16.04 installed on it .
the reason is this one find on internet . Ubuntu MATE does not boot on the 3B+ and 3A+. The Pi 3B and Pi 2B v1.2 use the first revision of the BCM2837 SoC, known as the BCM2837A0. The Pi 3B+ and 3A+ use the second revision of the BCM2837 SoC known as the BCM2837B0. This revision isn’t too different to the first revision other than the fact that it supports PoE (Power over Ethernet) and is clocked at 1.4GHz by default. For Pi models that use the BCM2837B0 to boot, the bootloader (bootcode.bin, *.elf, *.dat) needs to support this SoC. Unfortunately, Ubuntu MATE comes with an old version of the bootloader incompatible with the BCM2837B0. This is why you won’t get past the rainbow screen if you try to boot Ubuntu MATE on the 3B+ or 3A+.
Raspbian works well , is it possible to install Stellarmate on Raspbian or other system ?
Read More...