Hello,I'm using Ekos on astroberry with a ZWO EAF focuser, I got for my birthday from my kids. I looked around a bit and these are the settings I've tried (found info on this forum):
Settings tab:
Full field: checked
Box: 64px
Annulus: 25% - 80%
Settle: 0
Process:
Detection: SEP
Kernel size: 5
Sigma: 1.5
SEP Profile: focus default
Algorithm: Linear
Tolerance: 5%
Average over 2 frames
When I start the automatic focus process - after I focused manually, it starts far out (or in), with donnut-shaped stars, at some point it reaches (imho) nice focus but continues and stops with donnut shaped stars. I've read somewhere that with a Newtonian it's not easy to use an automatic focus process, due to the secondary mirror shadow when out of focus.Can anybody please advise what settings I can use for my setup, or should I forget about automatic focussing with a newtonian?Thanks and kind regards,
Look in the focus Mechanices tab
Read / search the focus topics in the forum about setting the initial step size ( about 1/2 CFZ), step multiple (about x4 CFZ) adjust to get a decent V curve.
I am not too good at this yet but set focus via Ekos "manually" using the non auto focus controls and note the number of steps when it looks to be in focus.
Then considering the initial step size and the step multiple and the above in focus value cause the auto focus to start with a value not too too far above the manual in focus value.
That seems to allow the auto focus routine to form the V curve without too many tries and reverse back over it successfully.