So just got a Celestron Focus Motor for SCT installed and calibrated using the hand controller.
I got it working last night using the USB and a separate power supply via astroberry just as the clouds began to roll in.
I never got the focuser to "connect" in Ekos using only the Aux port.
Under the "Profile Editor" -> "Focuser" section, I selected "Celestron SCT"
I THINK I also tried selecting "Celestron SCT" under the aux drop down, but am not sure. I think when I tried that I was having communication problems with the mount (incorrectly configured serial connections;)
Is there a different driver that I need to install on my Pi 4 running astroberry?
Bottom line is how do I configure my Celestron focuser in the profile editor to work via the aux port of my CGEM controlled by ekos via the hand controller?
Thanks!
Last edit: 3 years 11 months ago by Jason. Reason: clarity
Sorry if this reply is repeated, I submitted twice but could not see my reply.
I also have this problem. Stellarmate, connected via USB to MiniUSB into the bottom of the hand controller of a NexStar Evolution mount. In Stellarmate I read that for an Evolution mount I should use the newer Celestron AUX driver, this seems to work fine for driving the mount, but I cannot see the Celestron SCT Focuser anywhere. I am at a bit of a loss, any advise would be much appreciated.