Hello,
Tonight was clear despite the bad forecast so I gave my setup a try.
Was using a quite recent nightly build of Windows client. Two CCD cameras.
Let me start with the problem first.
-- Live View doesn't work for ZWO ASI1600MC when in 16bit mode. Getting white frames with some noise.
Preview (16bit) works fine. Live View in 8bit works fine.
Secondly, a couple of issues I had before got resolved (or almost resolved)
-- FITS histogram/image look much better now
-- Polar Alignment now works (it wouldn't refresh images before). Now it refreshes but stopps refreshing after about 3 min saying that it was done with the procedure (I didn't double check this one).
(Oh, great! KStars just crashed! I was shooting the Owl Nebula at the moment. It was running for about 4 hours. I did many different things with it. Just crashed while I was writing this post (same PC)).
Thanks!
-- Max S
ZWO AM5. RST-135. AZ-GTI. HEQ5. iOptron SkyTracker.
TPO RC6. FRA400. Rokinon 135 and other lenses.
ZWO ASI2600MC. D5500 modified with UVIR clip-in filter.
ZWO ASI120MM Mini x 2. ZWO 30F4 guider. Orion 50mm guider.
ZWO EAF x 3.
White frames mean that the pixel values are all zero. What gain were you using with the Live View? I usually set the gain to 800 or so when using the Live View. When I start imaging I set it back to 139 and offset to 21 (unity gain).
Any news on this topic?
I don't have an electronic focuser yet and do my focusing in live view. But in the middle of the night, I often forget to set the mode back to 16 bit and wake up with a whole night's worth of 8bit images.
If only entering live view would temporarily set 8bit mode and revert back to 16bit on exit...
Had that been changed? I also had lots of problems with 16bit stream, and stopped using it, but just last week found out that it nicely works now, which is really great!