Hi PDB,
I found the exact entry you referred to
It was already commented out !
Not sure whether to laugh, cry or just buy a new cable.
Actually, I've ordered a new cable
Best,
c
Read More...
@Avo
Yes, there are many reports of cloned/fake so-called prolific chips.
However, do bear in mind that in this instance (Eq6-r Pro) Well, I'd like (Hope) to think Skywatcher buys direct from Prolific ?
Best,
c
Read More...
Hi Avo,
Yep, I guessed it was vnc or similar
I'm just saying is there APPEARS to be something flakey going on in relationship to the pl2303 driver.
Do you know if your Pegasus is using the "standard" Prolific pl2303 driver ? It would just be interesting to know
Best,
c
Read More...
Hi nMac,
the range of experiences with all this stuff is really quite odd. Makes you wonder if it just all depends on which side of the bed you got out of
Best,
c
Read More...
@ Avo
forgot to say that this looks like a Prolific pl2303 driver problem specifically
Read More...
Hi Avo,
I've messed around quite a lot with this and it's all a tad confusing - for something so apparently simple it's bizarre ! I now strongly suspect that in this case it is a buggy driver implementation. I don't know which piece has the dodgy implementation, whether it be Astroberry/Debian/INDI et al or a straight defect in this particular driver.
I've used FTDI, Prolific, and the bargain bucket jobs for MANY years. I've never had a problem like this.
I'm pretty sure it's not the prolific hardware per se. If it was, they'd be out of business
Looks like my options are buy or make something.
I have the bits to make something, just can't locate a verified pin-out diagram. Looks like FLO will be getting an order
Oh, thanks for taking the time to make the screen shot.
Best
c
Read More...
@Hy.
Thanks for the thought. I may ultimately have to resort to something like this.
Best,
c
Read More...
Hi PDB.
I just looked for the file at the location you suggested and it doesn't exist.
Thanks for the suggestion though - another tool in the bag
Yes, I'm running a Mac and remoting into a pi running Astroberry.
Oh well. Onwards and upwards.....
Best,
c
Read More...
Hello Hy. Many thanks for your suggestions
Yes, there are a few ways I could go with this. I have tried connecting to the mount using AstroTelescope which worked fine (I needed to know if my mount was broken so I went back to the fundamentals) although it would only connect at 9600 bps.
I happen to have an FTDI FT232 ttl cable and I'm wondering if I can "spoof" INDI by making it think it has an FTDI interface. As I say, I'm not sure how to proceed. I need to sit and think for a while - but not tonight, it's way past my bedtime and my head hurts
Thanks again for your suggestions, I'll add them to the mix - so to speak.
As they say. Tomorrow's another day.
Best regards,
cas
Read More...
Hello. Very interesting information. Unfortunately I'm in this situation. I have a Moonlight focuser which uses the FTDI driver and my mount (EQ6-R Pro) uses the Prolific driver. I can't get my mount connected I'm not sure how to proceed.
Any suggestions you might have will be gratefully recieved. Both of these devices are quite expensive and I just can't afford to replace either.
No one said it would be easy
cas
Read More...
Hi,
thanks for the reply. Sorry, more questions.......
Did you have to compile from source ?
Are you Plate-Solving on the Pi ?
Is buster easy to get hold of ? (Not Pi savvy) Been doing stuff on Arduino.
Grateful if you have time to reply.
Regards,
cas
Read More...