I‘m connected over usb. I‘ve just seen i have to set the maximum ticks. Maybe it‘s because of that?
Read More...
Thanks for your hint! I figured out now that I have to use “quick sync ft hi-speed to work properly.
Best regards
Frank
Read More...
Hello,
which Motor shall I select when I have an HSM20? Is this Motor already supported?
Product Page
Best Regards
Frank
Read More...
Thanks for your help!
I take the roll_off driver as template and use the gson source and header directly from weather folder.
Clear Skies!
Frank
Read More...
Hello,
my name is Frank and I'm new here. I like to write a indi driver for my observatory roof using a Raspberry PI with the Razberry Z-Wave Module which has an Restful API.
I use two Z-Wave door sensors as limit switch and a Z-Wave relay to pulse my modified garage door opener. I have already an configured test setup on my table and i can simulate all steps manually by the browser.
I plan to make the api calls with curl but i need to parse the response from json.
My current issue is to find a common license compatible c/c++ library.
Can you give me some recommendations?
Read More...
Hello,
my name is Frank and I'm new here. I like to write a indi driver for my observatory roof using a Raspberry PI with the Razberry Z-Wave Module which has an Restful API.
I use two Z-Wave door sensors as limit switch and a Z-Wave relay to pulse my modified garage door opener. I have already an configured test setup on my table and i can simulate all steps manually by the browser.
I plan to make the api calls with curl but i need to parse the response from json.
My current issue is to find a common license compatible c/c++ library.
Can you give me some recommendations?
Read More...