Everything was working fine, and then I installed KStars/Ekos on a new PC, and tried to make a new remote connection to my Stellar Mate. I created a new profile through the web manager (
stellarmate.local:8624
) and saved this, restarted, and now I cannot get back to the web manager! I have a static IP address set, and left the ports as default - but it appears to be refusing the connection now.
I can still successfully VNC connect to stellar mate, and my "local" INDI profile still works when running KStars/Ekos.
Should I re-install INDI Web Manager? Or is there a manual way to force a reset?
Read More...
Thanks for your reply @xsnrg, very helpful!
So far, the mount has been working fine (using INDI_EQMOD, with the EQDirect-USB cable to my Orion Atlas Pro). But I will try just booting on with only the GPS device, and see what I can find out.
Read More...
I am looking for direction on how to setup my USB GPS device, which is the
USGlobalsat BU-353-S4
. The device uses the Prolific USB to Serial connection, and I have used the serial port mapping assistant to assign the port.
I cannot seem to get the GPSD to recognize the device and connect - do I need to install the Linux driver from Globalsat? I am setting this up on my Stellar Mate.
Thanks!
Read More...
Hey there,
I am new to this community, and not much of a programmer myself but I am starting to learn!
I wanted to inquire if anyone is using a USB...Hey there,
I am new to this community, and not much of a programmer myself but I am starting to learn!
I wanted to inquire if anyone is using a USB GPS device with INDI/Ekos to pull position and time sync? I have a Globalsat BU-353-S4 GPS. This was how I populated EQMOD previously.
Show more