I run astroberry-server on a RPI3 and I am very happy with it.
All updates have been done (astroberry scripts and mate packages.
I am less happy with my actual focus motor and so I have tried to use the rpi_focus.
I have installed INDI Astroberry from the .deb file at
sourceforge.net/projects/astroberry/
and I believe I used the required procedures (i said: I believe).
When I try to load the indi_rpifocus driver in indiserver (through graphical interface of EKOS configurator), no Astroberry Focuser tab shows up in focuser list.
Here is what I have done:
# from
www.airspayce.com/mikem/bcm2835/index.html
# download the latest version of the library, say bcm2835-1.xx.tar.gz, then:
tar zxvf bcm2835-1.xx.tar.gz
cd bcm2835-1.xx
./configure
make
sudo make check
sudo make install
installed armf rpi (.deb) packaged indi driver (rev 1.04)
# not done what follows since I use a raspi3 and this is
# for RPI2 enable device tree support
# and I have not found that kind of setting in the raspi3 version of raspi-config
# sudo raspi-config
# under Advanced Options - enable Device Tree
Reboot.
I have also tried to install this afterward in the hope to get missing libs
but this does not seem to improve anything:
sudo apt-get install sense-hat
The rpi_GPS appears in the picklists but no rpi_focuser