Robofocus not doing steps when pressing focus out or in, in Ubunto mate 16.04. Works perfectly in Ubuntu 16.04 and 17.04.
Read More...
Qsi filter wheel, after doing a upgrade unable to add a name to individual filter. Qsi CCD device crashes. Iam running 16.04 also tested on 17.04 does the same. The version of the Qsi ccd device is 3220 i think. Has any body had the same???? Is there a fix.
Read More...
Qsi filter wheel naming throughing an error after i did an upgrade, worked perfectly before???? Qsi service crashed
Read More...
Success, connected to the Arduino. You mentioned "Connect your relay box to arduino as instructed in indiduino site" I cannot find any maybe I am just getting old. Could you nudge me in the right direction I would appreciate this as I am literally days old in using the Arduino. Can I use any of the relay board for the Arduino?
Many Thanks Adam
Read More...
Arduino has a usb port and I didn't upload indiduino. I am not shore how to do this or what version type and where to download it from, I am very new to Arduino.
Thanks again
Read More...
hi
I've checked the port it is correct . ttyAMC0. What do you set up on the Arduino? this bit I don't understand.
Thanks for replaying
Read More...
Hi
New be to the Forum .
Firstly I would like to thank you for a most amazing interface. I have managed to put the necessary parts together and I am controlling my telescope ccd through Raspberry remote and client. So I tried Arduino basic switcher and everything went ok and connected to the driver. Client showed gui interface with all the sockets, I pressed the connect button and all I got was a yellow light?? I disconnected Arduino and reconnected with the client and I got a red light. So I am connected but nothing is happening. Hopefully you could enlighten me what to do next and is it my mistake.
Hope to hear from you soon joe90
Read More...