Hi Jens and Jasem
Ok an update from my side. I have managed to get the
ATR3CMOS26000KMA working on RPI3 and 4 / Astroberry at least some 1st basic operation.
1) I have checked
power supply and current to make sure that the RPi doesnt report low voltage as I was getting quite some voltage drop to the camera (it draws just over 2Amp when chilling
2) I've tried different
powered USB2 and USB3 hubs but that had no effect on the report of usb resource availability so I pushed on regardless
3) With some help I've tested the sample python apps provided with the
Rising Cam python / linux SDK and they both work so its possible to communicate with and use the imaging side of the camera - these use the nncam lib
4) For
INDI I tried all of the camera variants in the =11.0ptindi_toupbase.xml file and found that the Levenuk driver based upon nncam will work - its a not great to use but its possible to control most aspects of the camera including capturing FITS image file and creating SER videos - but only from the INDI control panel. To achieve this:
a) I swappend the libnncam.so file from the SDK with that on the std Astroberry build
5) I havent managed to get oacapture working, I think I need to learn how to add a camera because the default install doesnt appear to offer named cameras. I found an old post on that
indilib.org/forum/ccds-dslrs/1630-st4-ca...i/27397.html?start=0 but havent managed to figure out exactly what to do
@Jens - I am still new to INDI so please can you provide the steps you used to build the INDI driver ? did you have success then with oacapture or other RPI/Astroberry/Raspain capture porg ?
@Jasem - thanks for the link - yes - seems the same
I'll invstigate further this week and try to do a full write up - share here and back with Rising Cam
Thanks Gray